Bulgaria PHP Conference


(PHP 4, PHP 5)

pcloseFerme un processus de pointeur de fichier


int pclose ( resource $handle )

Ferme un processus de pointeur de fichier ouvert avec la fonction popen().

Liste de paramètres


Le pointeur de fichier doit être valide, et avoir été ouvert correctement par popen().

Valeurs de retour

Retourne le statut final du processus exécuté ou -1 en cas d'echec.


Exemple #1 Exemple avec pclose()



Note: Unix seulement :

pclose() est implémenté en interne en utilisant l'appel système waitpid(3). Pour obtenir le code de statut réel de sortie, la fonction pcntl_wexitstatus() devrait être utilisée.

Voir aussi

  • popen() - Crée un processus de pointeur de fichier

add a note add a note

User Contributed Notes 3 notes

6 years ago
The termination status, as pointed out in another note, is not the same as the exit status from the process. However, something like "pclose($fp)/256" is not the correct way to extract the exit status, since this uses system- and version-specific knowledge of where in the termination status the exit status is stored. (Also, the process may not even have exited normally, so it may not have an exit status at all.)

Instead, the functions pcntl_wifexited() and pcntl_wexitstatus() should be used. They are wrappers for the C macros WIFEXITED() and WEXITSTATUS() that are designed for determining whether the process had an exit status and what that status was, respectively.
vdweij at mailsurf dot com
11 years ago
As I understand pclose will return 0 (on every platform) in case popen could not execute the specified command.

Since popen only returns the status wether it was able to send a command and not wether it was succesfully executed. Only the returned value of pclose can be used to check wether a command could be executed.
kcross at nssolutions dot com
11 years ago
Somewhere between 4.1.1 and 4.2.3, the return value from pclose changed.

The exit status used to be in the second byte, so that the status would be (pclose($fp)/256).

It is now in the low-order byte, so the status is just pclose($fp).

Be careful.
To Top